Nozzle, pipeline, valve cover and other parts of diesel generators are likely part of the oil spill, not only increases the operating costs, will also reduce the effect of power generation, so let's look at the problem of oil leakage of how fast processing of diesel generator.
Nozzle oil return nozzle is a precision component. If you use clean diesel or equipment used for a long time, will be due to the nozzle wear and oil return. However, the high cost of replacement nozzle, in order to avoid missing oil return, you can return to the oil tank through the return pipe, or the introduction of diesel filters. If the return pipe is damaged, can be a plastic tube, the oil into their own container, filtered and then back into the tank.
  Oil spills: part can be divided for appropriate treatment: washer uneven pipeline hollow screw, washer can be unloaded, and then polishing pad, such as can not solve the problem, can be replaced with new gaskets, or soft plastic material thick cut gaskets replaced; plastic and metal pipeline leakage the joint, mostly plastic pipeline rupture caused by hardening or cut, hardening, rupture, and then use hot water soft, hot metal in the joint, and then the metal wire tie; metal pipeline rupture leak can be ruptured by brazing. In addition, in order to prevent the pipeline rupture, installed in the pipeline, camber should be appropriate, not hard pull installation, pipe body and body don't contact, avoid to wear.
  Valve cover oil: valve cover in installation, such as the tightening force is too large, easy to deform the oil spill. At this time, the leakage of the valve chamber cover down, carefully thump with sticks shaping, to make the contact surface to restore smooth, then, then pad gasket can be installed.
  Methods described above can help you deal with the problem of oil leakage for simple, easy to spill the part you need to focus on daily maintenance, pay attention to wear effects on accessories. And the failure of some rubber parts.